Join us on Discord!
You can help CodeWalrus stay online by donating here.
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - ArchReaper450

#1
All the games I downloaded were American I'm still messing with the pot setting and we'll see if it goes though eventually.
#2
Err my earlier message didn't go though apparently. Well, thanks for the help, I got the games to load up by messing with the pot. None of them really worked, RE Remake and Metroid Prime got in to the game but always crashed. :P

#3
Noooooooo I feel like it's going to be the dvd drive or it would load the version up.

I'll clean it and report back if it changes anything.
#4
Nada, the version won't load up or any of the backups but everything else works fine. Idk where to look now, I've checked the soldering and the power, I've swapped out the card x3 already.
#5
How long do I hold it? I tried holding it from the start and nothing appears.

Could it be a bad copy even though the version is not loading up?
#6
The original runs just fine on it. I tried resident evil the original and it runs.
#7
It starts (ACT lights up), stops (ACT lights down), restarts spinning(ACT lights up again), spins for awhile and either gives me an "insert a gamecube disc". Yeah, I noticed the switch to the right, I just put my e-tape on it  to hold it down.

If I press start from boot, it doesn't show me the version or anything. I have 2 different SD card, one with raspbian and the other with arch linux. Both have the kernel.img and both do the same thing.
#8
Thanks, I found them but It's not loading up Xenogc. The pi lights up and "tries" to patch through when I use a burned copy but I get nothing. ACT lights up on boot and when I insert a copy of too.
#9
Is there anywhere else I can pin gpio9? I pulled on the wire when my dog jumped on the table. The gold piece was stripped from the gamecube board
#10
Oh! My bad I was looking at the wrong board!
#11
Or at the very least I don't see it.
#12
Streetwalrus but when I look at the board from the back it doesn't look like yours so I don't know where to pin the raspberry.
#13
Alright, thanks.
#14
So it's not possible then?
#15
How do I rig this up for the DOL-CPU-10? the one supplied is for the revision models I have the earliest one.
Powered by EzPortal