Author Topic: Prime Linux  (Read 1738 times)

0 Members and 1 Guest are viewing this topic.

Offline Hooloowalrus

  • Full User
  • CodeWalrus Supporter
  • *
  • Safe-haven access
  • Join Date: Dec 2014
  • Location: Temporarily refracted into a free standing prism.
  • Posts: 24
  • Post Rating Ratio: +1/-0
  • super-intelligent shade of the color blue
  • Gender: Male
Re: Prime Linux
« on: September 02, 2017, 12:15:24 am »
I updated some stuff, so now loading DT and stuff should work. It appears as if the s3c framebuffer driver doesn't have any DT code in it at all, so I'm going to figure that part out before I start writing drivers of my own, like for the keypad.
  • Calculators owned: TI-83, TI-83+ purple, TI-83+SE, USB, TI-84+ SE, TI-84, Commodore PR-100, 4xTI-73, a couple TI-82s, TI-XXXXXXXXXXX, [blank] (nspire prototype), Nspire CAS+, Nspire Clickpad non-CAS, Nspire CX, HP Prime (lost in space), HP 50G, TI-92+


You can also use the following HTML or bulletin board code to share it on your page or forum signature!

Also do not forget to check our affiliates below.
Planet Casio TI-Planet BroniesQC BosaikNet Velocity Games